How To Connect A Second Router To My Network?

If you want to have two wireless routers over the same network, then you will have to set up one router as the primary one and the other one as a range extender or repeater. The repeater's main function is to boost the signals received from the primary router and help in forwarding the same signals to places where the connection used to get disconnected. The good thing about a Wi-Fi repeater is that it does not mess up the quality of the signal coming from the primary router and it also helps in increasing the network response time. There are several Wi-Fi extenders in the market, like D-Link, Netgear, Linksys, TP-Link, etc. But here, we are going to convert an old wireless router (secondary router) into a repeater/extender. Most of the modern-day routers have built-in features like access point mode, bridge mode, extender mode, etc. In such cases, all that you have to do is, enable the built-in feature and connect the secondary router to the primary router. If your secondary router does not possess the built-in feature to act as a repeater or extender, then you have to configure it manually. For that, initially, you have to assign an IP address to the secondary router. This IP address should be within the range of the primary router. Also, you have to disable the DHCP feature in the secondary router. Doing so will deny the device from acting as a router. Then you can add the secondary router to the network and use it as an extender. Carry out these below-mentioned steps how to connect a second router to my network.

Now, let’s see the steps to connect a second router to a network in detail. (Note: The steps given here are for the D-Link routers)

  • Step 1:Initially, make sure that your primary router has been well configured and set up.
  • Step 2:Before proceeding to configure the secondary (D-Link) router, reset it.
  • Step 3:After resetting the router, connect the secondary router to your computer using an Ethernet cable.
  • Step 4:Open a web browser on the computer and go to the D-link router’s settings page by entering its IP address.
  • Step 5:Now, use the default login credentials as follows:
  • Step 6:Username: admin
  • Step 7:Password: password
  • Step 8:Once you log in to the router’s settings page, click the Wireless tab on the top.
  • Step 9:The Wireless tab will open four sub-tabs on the left side of the screen. Click on the Wi-Fi repeater option.
  • Step 10:In the Wireless repeater setup window, click the Repeater Enabled checkbox.
  • Step 11:Now enter a name for your router in the SSID field or click on the Site Survey button to select the desired Access Point.
  • Step 12:On the next page, scroll down and select the access point of your choice. Then, click the Next button.
  • Step 13:Enter the password in the Pre Shared Key field and click Next.
  • Step 14:The next step is important, and it is where you have to enter the desired IP address that is of the same range as the primary router.
  • Step 15:Enter the subnet mask and click the Finish button.
  • Step 16:Now the configuration has been done.
  • Step 17:You can now unplug the secondary router from the computer.
  • Step 18:Connect an Ethernet cable between the LAN ports of the primary router and the secondary router.
  • Step 19:Place the secondary router in a place where you have a scarce internet connection.
  • Step 20:By using these steps on how to connect a second router to my network.

Now you have an additional router connected to your network, and also, this will help you boost the wireless signal range.