How To Reset Wps Router?

WPS or Wi-Fi Protected Setup is a feature that allows you to connect your wireless device to a wireless network without entering its credentials manually. In case there is an issue with the WPS mode of the router, then you can reset the router using the RESET button at the rear panel. In some router models such as NETGEAR D3600, TP-Link, etc., the WPS button and the Reset button are combined into one as the WPS/Reset button. So, some users get confused with these routers while enabling the WPS option or resetting the router. Now, if you own a WPS router and wish to know how to reset WPS router, then you’ve reached the right page to do it. In this section, the NETGEAR D3600 router and the TP-Link router are taken into consideration.

Resetting NETGEAR D3600:

As discussed above, the Reset button will be at the back of the router. To reset the router, follow the instructions given below.

  • Step 1 :Get a paperclip.
  • Step 2 :Make sure that your NETGEAR router is turned ON.
  • Step 3 :Now, hold down the WPS/Reset button for 6 to 15 seconds. Once the power LED of your router starts to blink, release the button. Now, the NETGEAR router will be reset to factory default settings. Continue reading to know more about how to reset WPS router.

Note: To enable WPS, press and hold the WPS/Reset button for 1 to 5 seconds.

Resetting TP-Link router:

    You can reset the TP-Link WPS router in two ways.
  • Step 1 :Using the WPS/RESET button
  • Step 2 :Using the router’s web interface

Using the WPS/RESET button:

  • Step 1 :Power on your TP-Link router.
  • Step 2 :Hold down the WPS/RESET button of the router for more than 10 seconds or until the SYS LED flashes faster.
  • Step 3 :Now, the router will be restored to the factory default settings.

Using the router’s web interface:

  • Step 1 :Go to the router’s web interface page.
  • Step 2 :Click Advanced > System Tools > Backup & Restore > Factory Default Restore > Factory Restore.

That’s it! Your TP-Link router is reset to the factory default settings. Finally you know how to reset WPS router.