Netgear Router Blue Light Blinking

  • Step 1:The blue Power button light on the router will be ON when the router is powered on. When you turn off your router and press the Power button on it, the blue LED light starts blinking.
  • Step 2:You could see an error message if the Power LED on your Netgear router is not solid blue. You might also see an error message if your Ethernet cables are not connected properly or your computer is behind a firewall.
  • Step 3:Sometimes, even if you try the hard reset or try updating the firmware, the blue LED light on your Netgear router might blink continuously.
  • Step 4:At times, when your Netgear router is not working, the light on your router will blink in blue.
  • Step 5:To resolve this issue, you need some recovery procedures. And there are a couple of requirements. They are:
  • Step 6:There must be a connection to the internet.
  • Step 7:There must be a DHCP server on your network.
  • Step 8:Refer to the following steps to resolve the issue of the blue light blinking on your Netgear router:
  • Step 9:First, you need to put your router in the recovery mode. To do this, you must power on the device and wait for fifteen seconds. After that, you need to hold the reset button while the boot-up happens.
  • Step 10:The boot-up process might take around 30 seconds, and during this period, the blue LED light on your router will keep blinking.
  • Step 11:Once the recovery mode is enabled, the blue LED light will turn off. The HDDLED1 will turn orange. You can release the reset button now.