Router Dropping Signal

Linksys router:

  • Step 1 :If your Linksys router is dropping signals frequently, proceed with the easy guidelines provided here to resolve this router dropping signal problem.

Low signal quality

  • Step 1 :The placement of the router is a major factor in getting a good signal strength.
  • Step 2 :You are strongly recommended to keep the router in the center of your house.
  • Step 3 :Make sure no obstacles are kept nearer to the router.

Maximum Transmission Unit (MTU) size

  • Step 1 :To get high signal strength, you have to determine and set up the correct MTU size of your wireless network.
  • Step 2 :To set up the correct MTU size, access the web-based setup page of the Linksys router using its IP address, username, and password.
  • Step 3 :Click the Setup tab followed by the Basic Setup tab, choose the Manual option from the MTU drop-down menu, and type the correct MTU size in the Size field.
  • Step 1 :Finally, select the Save Settings option.
  • Power cycle

    • Step 1 :Turn off the router and remove the power adapter from it.
    • Step 2 :Leave it for 10 seconds.
    • Step 3 :Connect the power adapter again to the router.
    • Step 4 :Power up the router and check if the router dropping signal problem is resolved.
    • Step 5 :If not, proceed with the steps given below.

    Step 1 - Resetting The Linksys Router

    Manual reset

    • Step 1 :Locate the Reset button that is at the bottom of the router and then hold it for about 30 seconds.
    • Step 2 :Note: Use a pen, paper clip, or similar objects to press the Reset button.
    • Step 3 :Now, the Power LED starts to blink. This indicates that the router has been reset to factory defaults.

    Software reset

    • Step 1 :Access the Linksys router’s web-based management page, go to the Administration tab and then click the Factory Defaults tab.
    • Step 2 :Select the Restore Factory Defaults option to fix router dropping signal issue.

    Step 2 - Reconfigure The Wireless Settings

  • Step 1 :Once done with the resetting the router, customize the wireless settings of the router.
  • Step 3 - Updating The Router’s Firmware

    • Step 1 :Download the firmware of the router from the official Linksys website.
    • Step 2 :Mostly, the file extension of the firmware file will be .bin.
    • Step 3 :Some of the router firmware has the .img and .bix file extension to avoid router dropping signal problem.
    • Step 4 :Use the router’s IP address to access the login page.
    • Step 5 :Provide the correct username and password in the appropriate fields.
    • Step 6 :This will open the router’s web-based management page.
    • Step 7 :Click the Administration tab followed by the Firmware Upgrade tab.
    • Step 8 :Select the Browse or Choose File option and choose the downloaded firmware file.
    • Step 9 :Once you click the Start Upgrade option, the router’s firmware will be upgraded.
    • Step 10 :Do not turn off the router during the firmware upgrade process.

    If you have queries in resolving the router dropping signal problem, click the Call button available here, and our technical support member will help you out.